Intermate Twinax Connection LX T-04 Manuel d'utilisateur télécharger pdf (Page 57)

A p p e n d i c e s

I n t e r m a t e L X T - 0 4 57

C. Operating the LX T-04

The SYSTEM indicator

This indicator (green) is lit when the Intermate LX T-04 is connected to your

IBM system. It can also flash under the following conditions:

Flash during a few seconds at power up.

Flash in Test Mode. Described later in this chapter.

Rapid flash during test function execution and during flash loading

of new software.

Note: If the power up flashing continues, a hardware error has occurred.

Contact your dealer/ distributor.

The Address Switch

The ten-position address switch is used to set the device address for the

Intermate LX T-04. It is also used to set start conditions and to select and

execute test functions during operation.

Start Conditions

The action when the Intermate LX T-04 is switched on is determined by the

setting of the address switch, as follows:

Pos. Description

0 - 6 Divice address in normal print operation.

7 Reserved.

8 Select IBM 4214 Printer emulation,

9 Perform a test printout.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 80 81

Pas de commentaire

Intermate Twinax Connection LX T-04 Manuel d'utilisateur Page 57